If the option is available, replacing your trailer floor can be a very rewarding project; it will not only extend the life of your vehicle but (and potentially more importantly) improve safety. If your old floor is rotted, cracked, or just worn out it can be tough to tackle but with a few tools and some careful planning you could do the work yourself.
Step 1: Rip Out the Old Floor
Empty the trailer and take off any accessories or hold-downs. Take a crowbar or drill and carefully lift up the old floorboards to remove them. Inspect the frame for rust or damage – you want to seal any problems before attaching new boards. For Trailer Parts, contact https://autoandtrailer.com/
Step 2: Measure and Cut
Use your measuring tape and measure carefully out an inch or two total longer than the width the trailer bed will allow between wheel wells, any unique flares leading up to these (on trailers with a narrow front) etc. Select the material that has durability such as treated plywood, hardwood or composite boards. Make a snug cut to fit on the either side of your new boards so as not leave any big gaps.
Step 3: Install the New Floor
Install new boards where the old ones were, using galvanized screws or bolts. Secure for a rattle free finish by evenly spacing fasteners then insert and tighten them accordingly.
Step 4: Reinstall Fixtures
Slide retraction and any tie down or accessories back into the new floor closest to the door. Check everything again so that the floor is secured and level.
By properly prepping and using the correct materials, you will have a strong as well as durable trailer floor that should give years of good service.
Leave a Reply